Not bulletproof is that it could not help heavy jitter with the Provia 400F carts tested on more cams. However, bad PRO8 perfs may be one reason for this and it does not fit my Canon 1014 XLS very well. Causes occational jamming due to too tight tolerances.
Below you can check out a clip originally not intended for public use.
The jumpiness is a projector artifact. Used a non gate adjusted RUSS projector for trash transfer.
This is s double exposure with a slightly offset 2. take.
For steadiness examination the lines over lines steadiness will be the measure.
Severly underexposed but only made for own verification - not posting. Anyway here it is. It is a 5 sec clip repeated 4 times.
ftp://ftp.filmshooting.com/upload/video/mov/NR10s.mov 6+mb.
The mod made to allow full operation of the stop pin: Not actual plate but this is how it looks. Special steel colour marker is added to the stop pin prior to cart + PP insertion but no film should be in thie gate, The stop pin will "print" where it hits the plate and it is possible to make the mod. Ideally only a narrow slot or 2 holes (there are 2 pins - one for FW and one for RW operation) should/could have been made but I removed this entire section to ensure compability.
R