Christopher Brims

Is there a source for a replacement resistor or is it just hand rewind it or replace with a potentiometer? As far as splicing, that's how I found the film from when my dad was in his 20s; I'm just trying to make the best of what I've got. I'll look around and see what comes up for super 8.

My Bolex M8 arrived yesterday, I cleaned all the dust off it, plugged it in, and turned it on. The lamp works, motor runs, etc. I ran an inexpensive film I bought through it. All was well except the speed control, that doesn't work. When I opened the bottom of the case, the 2 resistive coils are coming apart. I'm currently contacting some companies that Bolex told me to contact to replace that part. Also I need to clean the film I want to run, when I rewound it I found a some taped splices where the tape has come off and left the adhesive. But I'm slowly progressing. I found running my test film through the projector rather interesting. I also found another regular 8 film, I think a 2 or 3 inch reel; it's in bad shape, the film is twisted. I also found another reel that is super 8; of course that would happen. I've been looking for super 8 projectors based on some searches from this and other forums, but those run from $400 to $1,000 which is a bit out of my price range. Any recommendations for a similar grade of super 8 projectors?

I figured the Brownie wasn't that great of a model, it's the one my dad had purchased; it sure is a PITA to clean and repair. It looks like I can get a decent looking Paillard-Bolex for not a lot of money, the Bell & Howell is a little out of my price range. I definately want to be gentle to the film, I know it's already seen a hard life. Thank you all for the advice and guidance.

I've got the Model 1. My dad purchased it on eBay some time ago, I had to take it apart to replace the power cord as it was falling apart. The tapered rubber piece attached to the motor doesn't engage properly both directions without some help, but I can make it work to go through 1 film. I'll take out the sprocket and check the teeth carefully. The gate looked smooth, I'll run some Q-tip heads or something over them to check for any burrs, I know it needs a little more cleaning with detail brushes. Where are the side guides located? I appreciate all the help I can get from the pros, it's one of better ways to learn.

I'll purchase some regular 8 film on eBay and run it through the projector. The projector works, I just haven't run any film through it as I don't want to risk what I have without a trial run. Thank you for your help.

Hello, this is my first post but I have questions about some old regular 8 film that my dad made many years ago. I need a viewer so I can look through the film and see what's on it so I can decide if I should get it transfered. I've seen a Goko GM-5005 and a Baia Model V-8 viewer on eBay. I've read that the Goko is a quality unit, but I don't know if it's compatible with regular 8. Also, it seems it may have been put on the spool wrong, possibly just not rewound. When looking at the side of the reel with the film coming off on the right side, the holes in the film are away from me. I tried loading it into a Kodak Brownie 300 projector according to the instructions and the holes are on the wrong side. Any help would be appreciated.