Jump to content
Sign in to follow this  
Igor Trajkovski

Effect of strong magnet in Viewfinder Loupe on the camera's LCD

Recommended Posts

In this review of the Kamerar QV-1 LCD Viewfinder,

the reviewer comments on the strong magnet holding the finder

to the mounting bracket and demonstrating it by holding

the DSLR downwards on the loupe only - LINK.

 

 

I wonder, is that magnet somehow affecting the LCD screen?
Temporarily or maybe over time causing some damage?

 

 

Didn't some users of s35 adapters for video cameras (remember those? :) )

attach magnet on screen or the viewfinder to un-flip the image?

 

 

Best

 

Igor

 

 

Edited by Igor Trajkovski

Share this post


Link to post
Share on other sites

I can't think of any reasons why the magnet would hurt any part of the camera, other than by perhaps magnetising steel parts inside which I guess could cause problems, maybe, but I am guessing.

 

CRT displays had problems with magnets. LCDs don't, as far as I'm aware.

 

P

Share this post


Link to post
Share on other sites

LCDs have no interaction with magnatism. People used magnets to flip EVFs, because back before iPhones made MEMS motion sensors cheap, they used sensors that simply worked off gravity. The magnet activated the switch, making the LCD think it was upsidedown when it was upright. Over time, especially if the magnet doesn't move much, it won't impart much magnatism on anything, and what little it does won't be enough to do anything adverse to an LCD or related components. Very little electronics these days are affected by permanent magnatism. Things change when that magnatism changes polarity often or a permanent magnet moves against a low voltage, heavily amplified trace without a feedback circuit (which these days is almost never).

 

Electronic design in the very few circuits that could be affected by magnetism or electromagnetic radiation when cell phones came into vogue. Magnets, even when moving, impart only a small fluctuation in most signal traces or wires, so it doesn't take much to design around these constraints. Almost all digital circuits are impervious to typical magnet induced current, or environmental EMI, because good luck getting a single short trace to absorb a 3.3v worth of magnetic induction from any magnetic or EMI source. (place a coil of high current, high voltage wire next to a wifi router. Odds are the range will be shortened, but it will still work reliably....unless you place it next to a 20K dimmer)

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  


  • CineLab



    New Pro Video - New and Used Equipment



    Visual Products



    Tai Audio



    Abel Cine



    G-Force Grips



    Paralinx LLC



    Wooden Camera



    Gamma Ray Digital Inc



    Serious Gear



    Media Blackout - Custom Cables and AKS



    Ritter Battery



    Rig Wheels Passport



    Just Cinema Gear



    Glidecam



    Metropolis Post



    Broadcast Solutions Inc



    FJS International


    Cinematography Books and Gear
×
×
  • Create New...