Jump to content

Sony F3L / Odyssey 7Q+ focus peaking oddness


Feli di Giorgio

Recommended Posts

I fired up the F3 today with the Odyssey 7Q+ and am seeing some very odd focus peaking behavior.

I snapped a picture below.

 

I'm seeing two problems.

 

The peaking is being cut off and only working on part of the frame. It looks a little like the peaking information is vertically out of sync and wrapping itself vertically around the display.

 

Sometimes the peaking works across the frame, but regardless when I pan or tilt I get focus peaking makers 'bunching up' along the bottom of the frame, again like they are wrapping around vertically from the top of the frame.

 

 

I tried several SDI cables and ran ithe F3 with one and two connections (1.5G / 3G) and get the same results.

 

The built in focus peeking on the small F3 screen or in the viewfinder doesn't not exhibit this problem.

 

I fed the SDI-A output into my Flanders and the peaking built into the monitor did not have this problem.

 

​I did a reset on the F3 and reinstalled the firmware on the Odyssey.

Has anyone else experienced this? Could it be a big in the odyssey firmware? The F3 appears to be working fine.

Thanks in advance

 


Feli di Giorgio

www.felidigiorgio.com

F3:

23.98
3G RGB444 S-LOG (I have the paid slog upgrade)
Two SDI cables to Qdyssey 7Q+


Odyssey 7Q+:

CAMERA: Sony
Monitor-Record: HD 444 Prores
Codec: Prores 444 / Prores 444XQ
Project rate: Follows input

Video Cadence: Progressive / PSF
Timecode source : SDI

 

post-60385-0-13160600-1541872281_thumb.jpg

Edited by Feli di Giorgio
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...