Joe Gill Share Posted November 11, 2019 I have 2 of their 35-3's and just noticed they have a modified socket with a square peg in it instead of the usual frame advance. Does anybody know if this is really a hand-crank or just for a direct drive motor or ? Does anybody then know where I can source two of these hand cranks? Attached is image of the socket. Thanks, Joe Quote Link to post Share on other sites
Joe Gill Author Share Posted November 11, 2019 Here is a picture of the connector: Quote Link to post Share on other sites
Richard Joneleit Share Posted November 11, 2019 I worked in the rental dept at Clairmont from 2006 to 2013 and there weren't any hand crank Arri 3s at that time - only somewhere between two and four 2C hand cranks. You could check with Andree Martin about that port, he'd know what it's for. I think there should be a cap for that port. Quote Link to post Share on other sites
Joe Gill Author Share Posted November 12, 2019 Thanks! There is a cap! Quote Link to post Share on other sites
Joe Gill Author Share Posted November 19, 2019 This is for a Norris Intervalometer, not a hand crank. One could be machined with a reduction gear, but I don't know if it will be done anytime soon. Thanks to Andree Martin for helping figure this out! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.