Search the Community
Showing results for tags 'wide-angle lens'.
Found 1 result
Hey everyone! This is a continuation of the thread where I was asking for some ideas on how to filter my 9mm lens since the matte box was showing in the field of view. Please see the original thread (http://www.cinematography.com/index.php?showtopic=65936&hl=) as the suggestions and information contributed were quite helpful! (Thanks to Gregg, Miguel & Dennis.) DISCLAIMER: I haven't shot anything using this set-up yet, but it looks like it will get the job done. I am always hesitant to post any kind of tutorial, but I think this is pretty neat! So here's the solution I came up with :) ... Items required: -Alligator clips -Household pull-string with tassel at end -Gaffer's tape My first concern is always keeping all of my equipment in excellent condition. It was obvious that I would need to place the filter directly in front of my 9mm Cooke lens, but I really didn't want to put any kind of tape on the filter itself. So... 1- Fold 2 very small pieces of gaffer's tape onto each side of the filter with the non-adhesive sides touching the filter. These pieces act as a cushion so that the alligator clips never touch the surface of the filter. 2- Attach the alligator clip to the upper right-hand corner of the filter. 3- Put the pull-string through the circular notch on the front of the camera until it reaches the tassel. Tape the beaded end of the of the pull-string to the circular end of the alligator clip. This is your first fastener. 4- Pull the string back so that the filter is close to the lens and the tassel falls to the bottom of the camera on the left-hand side. Repeat steps 1 & 2, then tape the tassel end of the pull-string to the second alligator clip on the lower left-hand corner of the filter. This is your second fastener. 5- At this point, you may need to start attaching some gaffer's tape - first to the pull-string & then to the camera - for some tension. 6- Repeat steps 1 & 2, and attach the third (and final) alligator clip to the lower right-hand corner of the filter. This is your third fastener and it is a "floating clip" in that it does not get attached to the pull-string. Put gaffer's tape on the circular end of the alligator clip and attach it to the right-hand side of the camera. 7- Adjust for tension as needed. You should still have the ability to adjust the f-ring. Here are some pictures of the final product! Sorry I didn't take any step-by-step pictures, but I hope this helps for anyone with the same issue! It may not look sexy, but it seems like a pretty good rig for $5.00. Thanks for reading and comments/critiques are always welcome! Happy New Year!