Dennis Riebenstahl

2 hours ago, Raymond Zananiri said:

B&H carry it and they ship worldwide. Unless of course there are restrictions for batteries in particular. 

https://www.bhphotovideo.com/c/product/1048193-REG/bescor_fp_12vatm_12v_lithium_ion_battery.html

Awesome, thanks again, Raymond!

On 1/15/2021 at 6:06 AM, Raymond Zananiri said:

I use this battery on my 35iii and it works fine. It is also quite lightweight. 

https://www.bescor.com/product-page/fp12vatm

[...]

Unfortunately, Bescor doesn’t ship to Germany and I can’t find the same setup here.

But I bought a D-Tap to 4-Pin XLR cable and I’m using my 14.4V Anton Bauer batteries for now. The camera runs very well at all speeds, but of course it’s quite a bit of added weight.

Perfect!

That’s what I was looking for. Thank you so much, Raymond!

For how long can you run the camera on one charge?

EDIT: By my calculation a bit over three hours total running time? (@24fps)

Hello all,

I wasn't sure whether to create a new topic for this—I know that some message boards look down on that—but I have a question relating to the Arriflex 35 III:

I need a power source for it. Is it as simple as getting a battery with the right specs and fix it with the right 4-Pin connector?

The original manual calls for a 12V / 7Ah NC battery.

There are two battery 4-pin sockets on the camera one on the baseplate and one on the camera itself. I would like to power it only through the baseplate.

Ideally (and I cannot stress enough how little I know about some of these technical issues) I could connect the gold-mount anton bauer batteries I already own and craft some sort of D-Tap to 4-Pin cable. Is that even possible?

Your input will be greatly appreciated!