Dennis Riebenstahl

Awesome, thanks again, Raymond!

Unfortunately, Bescor doesn’t ship to Germany and I can’t find the same setup here. But I bought a D-Tap to 4-Pin XLR cable and I’m using my 14.4V Anton Bauer batteries for now. The camera runs very well at all speeds, but of course it’s quite a bit of added weight.

Perfect! That’s what I was looking for. Thank you so much, Raymond! For how long can you run the camera on one charge? EDIT: By my calculation a bit over three hours total running time? (@24fps)

Hello all, I wasn't sure whether to create a new topic for this—I know that some message boards look down on that—but I have a question relating to the Arriflex 35 III: I need a power source for it. Is it as simple as getting a battery with the right specs and fix it with the right 4-Pin connector? The original manual calls for a 12V / 7Ah NC battery. There are two battery 4-pin sockets on the camera one on the baseplate and one on the camera itself. I would like to power it only through the baseplate. Ideally (and I cannot stress enough how little I know about some of these technical issues) I could connect the gold-mount anton bauer batteries I already own and craft some sort of D-Tap to 4-Pin cable. Is that even possible? Your input will be greatly appreciated!