Search the Community
Showing results for tags 'home developing'.
-
Hi all, this is my first post here. Over winter break I got bored and decided to try learning some CAD to make a new lomo like spiral tank for 16mm (or in my case double 8), because the results from a Morse G3 just aren't cutting it. Its by no means refined, but in theory it should hold 100' of 16mm film. I was going to do a test 3D print at a local makerspace, but then the pandemic moved in and that plan kinda fell apart. I looked online at a few places that do prototype printing, and the cheapest I found was about $110 including shipping, which is a bit much for me at the moment,
-
So as a project for high school some friends and I are going to shot a short on Super 8. I am planing on purchasing Kodak's 7266 Tri-X and I've been looking into developing it. I know that I can send it to get developed at Pro8mm or CineLab but if it's reasonable I'd like to try home developing. I've see a number of different ways in my research. I know the basic process of developing the film twice and bleaching it in the middle. I've read that I could just use D-76 for developing. But I've also read that I should use KODAK B&W Reversal First Developer Starter. I've read the instructi
- 16 replies