Jump to content

400ft magazine sensor... not sure it's working as it should

Constantin Dubois Choulik

Recommended Posts

Hi again, thanks for previous help on getting started with my "new" Eclair ACL II...


I have two 400ft mags and both seem to have a faulty sensor. Not sure the word is right, what I am referring to is the springed arm that is connected to the film counter window on the side of the mag.


On both of them mags, the spring seem to be working backwards. As i understand it, it should push the arm towards the center, to stay on the film left on the spool as it roll away. But on my mags the spring pulls towards the exterior, away from film. So it's useless...


I've taken it apart down to the spring and I just can't get it... any help would be much appreciated. Thanks !!!

Edited by Constantin Dubois Choulik
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...