Jump to content

Are stand riser diameters standardized?


Rick Gates
 Share

Recommended Posts

I recently made a decision to try out some of Kupo's 3-way and 4-way clamps as a way to lower my gear footprint.  The clamps wrap around the riser portion of c-stands and combos, and hold baby spigots and receivers and J-hooks and such.

So I measured my stand's riser diameters to see where the clamps could fit.  Turns out that the three risers on my c-stands measure (from bottom up), 35mm, 30mm and 25mm.  And the risers of the combo stands are 45mm, 40mm, 35mm and 30mm .  There's 5mm difference in diameter between each riser.

But all my c-stands and combos are Avenger products.  Is the 5mm difference standard to all c-stands and combos, or just Avenger?

Link to comment
Share on other sites

Wow, that's way thinner than my Avenger C-stands, which in SAE are 1 3/8", 1 3/16", and 1".  The gobo arm on the C-stand is 5/8", same as a baby pin.

Good to know.  Thanks!

Edited by Rick Gates
Last sentence
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

Forum Sponsors

Visual Products

VidGear.com - Broadcast Video Warehouse

FJS International

Film Gears

CineLab

Wooden Camera

Gamma Ray Digital Inc

Broadcast Solutions Inc

Serious Gear

Metropolis Post

Abel Cine

Tai Audio

New Pro Video - New and Used Equipment

Cinematography Books and Gear



×
×
  • Create New...