Bell and Howell Filmo help

[Andrew Hamilton Watts]

Hi all, 

I am hoping one of you with more experience can help me out with my Filmo 70DR. Earlier today I was out shooting some film when I noticed the winding key was loose. I pushed it back in and it seemed fine but when I hand the camera to my friend the key fell out. Now it seems like this is suppose to happen, but how do I get the key to stay back in without it falling out every time I tilt the camera? It had never done this before and I’m not sure exactly what I did to cause this.

Any advice would greatly help me!

best,

Andrew

[Simon Wyss]

The key should wear a piece of round wire as open ring near its joint. This ring snaps into a grooved bushing of the camera which may be engraved WIND. Give the folded-down key a dry blow with the palm of your hand to attach it.

[Andrew Hamilton Watts]

51 minutes ago, Simon Wyss said:

The key should wear a piece of round wire as open ring near its joint. This ring snaps into a grooved bushing of the camera which may be engraved WIND. Give the folded-down key a dry blow with the palm of your hand to attach it.

Yes! That did the trick! Thank you so much